crwdns2933803:012crwdne2933803:0
crwdns2933797:0Charlotte Prattcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Charlotte Pratt
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Stripping Pressure Transducer Wires | |
| - | [* red] Use cable cutters to take off about 6 inches of the thick black cable end. This may need to be done in smaller, 1 inch sections |
| + | [* red] Use coax cable cutters to take off about 6 inches of the thick black cable end. This may need to be done in smaller, 1 inch sections |
| [* orange] Use pliers to twist/pry off each smaller section of black cable. | |
| - | [* yellow] Next, trim the silver and black wire to the same length(about |
| + | [* yellow] Next, trim the silver and black wire to the same length(about 4 inches exposed). The red wire should be kept at 6 inches. |
| [* green] Use wire strippers to expose the inner silver wire from the black and red wires | |
| [* icon_note] After each section comes off, the blue wire and plastic can be completely cut away | |
| [* icon_note] The clear tube can be cut away a little bit to make it easier to pull the sections off, but make sure to leave a couple inches of it | |
| [* icon_caution] Be careful not to break or cut the other wires(the silver wire is especially fragile) |