crwdns2933803:06crwdne2933803:0
crwdns2933797:0Arthur Shicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Arthur Shi
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* red] Carefully flip the board over and note the two solder joints connected to the battery cables. | |
| [* black] De-solder the two solder joints and replace the battery. You will have to re-solder the battery to these contact points. | |
| - | [* icon_caution] Be very careful not to short the battery wires. The battery has no protection circuit and may overheat and ignite if shorted. |
| + | [* icon_note] Alternatively, cut the wires one-by-one before you desolder them. This will help prevent unintentional short circuitry. |
| + | [* icon_caution] Be very careful not to short the battery wires. Doing so may overheat and ignite the battery. |
| [* icon_note] Be sure to maintain the correct battery polarity when you re-solder the wires. | |
| [* black] The back of the board is shown for reference. |