crwdns2933803:03crwdne2933803:0
crwdns2933797:0Gerardo Longoriacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Gerardo Longoria
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] In-lab step: Ultrasonic Sensor | |
| [* red] Make sure that there is an O-ring on outside of the node. | |
| [* yellow] make sure to tighten the screw on the inside snuggly. | |
| [* blue] Make sure the wires are connected in this manner. From the edge it should be "black, red, white". The ultrasonic sensor has labels on it and GND (ground) is on the very end. Hence, the black wire on the end. | |
| - | [* icon_note] The other ends of the wires are connected to a 5-prong terminal block. That terminal block should be connected to the board at the following pins: P12.3 |
| + | [* icon_note] The other ends of the wires are connected to a 5-prong terminal block. That terminal block should be connected to the board at the following pins: P12.3 : White wire, P12.4 : Red wire, GND : Black wire. |