crwdns2933803:06crwdne2933803:0
crwdns2933797:0Wouter van der Postcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Wouter van der Post
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] The CD-ROM has to be pulled out straight up. Some force might be needed since the unit is plugged into the logic board at the bottom of the housing with a connector board (see the third photo). The board might come out with the CD-ROM unit, or still be connected to the logic board. | |
| [* yellow] At the left side, it might be possible to use fingers to pull out the unit. | |
| [* blue] At the right side, a flat head screwdriver can be used. The force that is needed will most likely bend a metal spudger. | |
| [* black] Once disconnected, flip over the CD-ROM unit and place it next to the housing with the logic board. | |
| [* violet] The brown cable will still be connected, optionally remove the one Torx screw located next to the cooling fan (see second photo) to disconnect the connector from the housing. | |
| - | [* icon_note] When assembling place the connector board on the logic board inside the housing. Push it down until the connector pins are visible at the surface of the connector board. |