crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0Jeff Suovanencrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Hold the Force Touch gasket diagonally to thread it over the display.
-[* black] Slightly tilt the display forward so you can align the Force Touch gasket with the frame.
-[* black] Starting on the corner opposite the force touch gasket connector, set the gasket onto the frame.
- [* icon_note] You can use the end of a spudger to press the new force touch gasket into place.
+[* black] With the exposed adhesive facing down, thread the Force Touch gasket down over the display (if connected) and set it into position in the case.
+ [* black] Slightly tilt the display forward so you can align the Force Touch gasket with the frame.
+ [* black] Make sure the connector lines up with its socket.
+[* icon_note] You can use the end of a pry tool to press the new Force Touch gasket into place all around the perimeter of the watch.