crwdns2933803:03crwdne2933803:0
crwdns2933797:0Elizabeth Claypoolcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Elizabeth Claypool
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* red] There are soldered points where wires connect the circuit board to the headphones. |
|---|---|
| - | [* icon_note] You will need to use the desolder pump and solder iron for the wires at the point where they connect to the circuit board. Read this [guide|750|guide] on how to do so. |
| + | [* red] Unsolder the three points where the wires connect to the circuit board. For detailed instructions on soldering, see this helpful [guide|750|guide]. |
| [* icon_reminder] Take note of where each of the wires goes to simplify the resoldering process. | |
| - | [* black] To replace the lights on the other ear muff, repeat these steps on the left ear muff. |
| - | [* icon_note] If this is the first time the lights have been removed from the headphones, you may need to wiggle the circuit board out of place or use plastic tweezers to loosen it from the manufacturer's adhesive. |
| - | [* black] Resolder a new light and circuit board unit to the wires you just removed. |
| + | [* black] Follow these steps again to replace the light on the other earcup. |