crwdns2933803:03crwdne2933803:0
crwdns2933797:0Ruhi Prasadcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ruhi Prasad
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Locate the soldered points where wires connect the circuit board to the headphones | |
| - | [* black] Following [%5Bhttps://www.ifixit.com/Guide/How+To+Solder+and+Desolder+Connections/750%7Cguide %5Dto learn how to solder and desolder|these instructions], desolder the wires at the point where they connect to the circuit board |
| - | [* black] You will need to use the desolder pump and solder iron for this step |
| - | [* black] Take note of where each of the wires goes to simplify the resoldering process |
| - | [* black] Read this [guide|750|guide]to learn how to solder and desolder |
| + | [* icon_note] You will need to use the desolder pump and solder iron for this step |
| + | [* black] Read this [guide|750|guide] to learn how to solder and desolder the wires at the point where they connect to the circuit board |
| + | [* icon_note] Take note of where each of the wires goes to simplify the resoldering process |
| [* black] To replace the lights on the other ear muff, repeat these steps on the left ear muff | |
| [* icon_note] If this is the first time the lights have been removed from the headphones, you may need to wiggle the circuit board out of place or use plastic tweezers to loosen it from the manufacturer's adhesive |