crwdns2933803:05crwdne2933803:0
crwdns2933797:0Adam O'Cambcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Apply adhesive |
|---|---|
| + | [* icon_note] If your part did not come with pre-cut adhesive, use high-bond double sided tape, or pieces of a [guide|113604|pre-cut adhesive sheet] to secure the camera bezel. |
| + | [* black] Cut pieces of tape to the appropriate size so they fit along the edges of the camera bezel. |
| + | [* icon_note] Measure the areas you want to apply tape to, and then mark those measurements on the tape with a pen to make sure each piece is the proper length and width. When in doubt, use a narrower size tape than you think you might need. |
| + | [* black] Use tweezers to apply the tape to the metal surface of the bezel, on the side where the camera lens cover protrudes. |
| + | [* black] Try to cover most of the metal surface of the bezel with tape. Avoid overlapping tape onto any plastic or glass areas. |