crwdns2933803:01crwdne2933803:0
crwdns2933797:0Ed Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ed D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Picture #1: GM VATS MODULE |
|---|---|
| + | [* black] Picture #2: Open the module being careful not to break these two small tabs. |
| + | [* black] Picture #3: It lifts out of the gray box. |
| + | [* black] Picture #4: I re-flow the solder on all the connector pins on the other side of this board and all 7 of the larger diodes and both blue color resistors between the diodes. |
| + | [* black] Picture #5: The screw driver tip is pointing out the solder joint that most likely not flow. That diode I use a solder sucker and remove all the solder and the diode. I then clean the board with flux and a small brush and a pencil eraser if needed being careful not to damage the eyelets on the board. I then reinstall the diode and solder it in. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0