crwdns2933803:03crwdne2933803:0
crwdns2933797:0Ivan Chavezcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ivan Chavez
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* icon_caution] Using the soldering iron can be very dangerous if not used carefully. Solder iron is very hot. |
|---|---|
| + | [* red] These are the two wires yoiu have to solder off the board. |
| + | [* black] Before using the soldering iron, give it a few minutes to heat up. |
| + | [* black] After a few minutes has passed by, hold the wires with tweezers in one hand and use the solder to heat up the tin from the board to detach the cables. As you touch the tin, pull gently on the wires to detach. |
| + | [* black] Once wires are detached, use a metal spudger tool to lift the vibrator. |
| + | [* icon_note] If the wire is not detaching from the tin, raise the heat on the solder. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0