crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Brandon Carvalhocrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Brandon Carvalho

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Locate and remove the 2 mm long phillips head screw on the SD Card Reader.
-[* black] using a plastic spudger, release the pressure connector marked with the green rectangle by gently prying up from below.
+[* black] Locate and remove the 2 mm long Phillips 000 head screw on the SD Card Reader.
+[* black] Using a plastic spudger, release the pressure connector marked with the green rectangle by gently prying up from below.
[* black] Once the pressure connector is undone, the white ribbon cable connected to the SD Card Reader will pull out with no resistance.
[* black] With the ribbon cable disconnected and the screw out, the SD Card Reader will be free to remove and replace.
- [* black] ''When replacing the SD Card Reader, ensure the ribbon cable is firmly secured in the pressure connector, with the metal contact points facing down towards the motherboard''.
+[* icon_note] ''When replacing the SD Card Reader, ensure the ribbon cable is firmly secured in the pressure connector, with the metal contact points facing down towards the motherboard''.