crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0Adam O'Cambcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Line up the rear camera bezel with the rear camera and flash cutouts on the rear glass, then set it down on the adhesive.
+[* black] Line up the rear camera bezel with the cutouts on the rear glass, then set it down on the adhesive.
[* black] Make sure the camera bezel is completely seated in the rear glass's camera cutout so that the bezel lays flat against the glass.
-[* black] Apply even pressure to the bezel for 30 seconds to make sure the adhesive bonds properly.
-[* black] When you are ready to install the rear glass, but before you seal the phone, peel off the black backing covering the camera glass.
+[* black] Use your fingers to apply even pressure to the bezel for 30 seconds to make sure the adhesive bonds properly.
+[* black] Immediately before you install the rear glass and seal the phone, peel off the black backing covering the camera glass.