crwdns2933803:07crwdne2933803:0
crwdns2933797:0Adam O'Cambcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Line up the rear camera bezel with the rear camera and flash cutouts, then set it down on the adhesive. |
|---|---|
| - | [* black] Make sure the camera bezel is completely seated in the rear glass's camera cutout so that the bezel |
| + | [* black] Line up the rear camera bezel with the rear camera and flash cutouts on the rear glass, then set it down on the adhesive. |
| + | [* black] Make sure the camera bezel is completely seated in the rear glass's camera cutout so that the bezel lays flat against the glass. |
| [* black] Apply even pressure to the bezel for 30 seconds to make sure the adhesive bonds properly. | |
| + | [* black] When you are ready to install the rear glass, but before you seal the phone, peel off the black backing covering the camera glass. |