crwdns2933803:05crwdne2933803:0
crwdns2933797:0Adam O'Cambcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Peel away the clear backing from the camera bezel adhesive strip, exposing the adhesive on one side. | |
| [* black] Very carefully line up the rear camera and flash cutouts on inside of the rear glass with the same cutouts on the adhesive strip. | |
| [* black] Set the adhesive strip on the rear glass and make sure it does not overlap the edges of the camera or flash cutouts at all. | |
| [* black] Use your fingers or the flat edge of a spudger to press the adhesive down so that it bonds to the glass. | |
| [* black] Peel the green backing away from the adhesive strip. Make sure the adhesive does not come off of the glass with the backing. | |
| + | [* icon_note] If your part did not come with pre-cut adhesive, use high-bond double sided tape, such as [product|IF317-072-1|Tesa 61395|new_window=true], or pieces of a [guide|113604|pre-cut adhesive sheet|new_window=true] to secure the camera bezel. |