crwdns2933803:028crwdne2933803:0
crwdns2933797:0Jeff Suovanencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* icon_reminder] When reinstalling the logic board assembly: |
|---|---|
| + | [* black] Check the alignment of the rubber vibration dampers, and adjust them as needed. |
| + | [* red] Verify that no cables get trapped under the board as you install it. Check each marked location carefully. |
| + | [* orange] Feed the antenna cable bundle through the gap between the logic board and heat sink and make sure it lines up correctly. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0