crwdns2933803:02crwdne2933803:0
crwdns2933797:0Felix Cies.crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Felix Cies.
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Open the housing |
|---|---|
| + | [* black] Remove the turntable plate by lifting it up. It rests on a cone at the center axis. |
| + | [* black] Pull up the small cover plate for the "remote control start/stop" plug allocated at the backside. It is fixed with double-sided adhesive tape |
| + | [* black] For turning around the turntable put maybe two books beside the main axis . So that the device is not resting at the main axis! |
| + | [* black] Loosen 8 screws with a Phillips screwdriver at the bottum of the turntabel. (signed red in picture). |
| + | [* black] Be aware that under every screw a spacing ring is allocated, the will fall away while opening the housing. (It is not a big problem during reassembling later) |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0