crwdns2933803:03crwdne2933803:0
crwdns2933797:0watchmaniacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 watchmania
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Teardown |
|---|---|
| [* black] Now to the main part. First step is to remove the board from the case and to do some modifications to attach the battery holder to the case. | |
| [* black] (1) This might be the trickiest part of the upgrade. The Ugreen case opening can be found on the bottom of the device, neatly glued. Carefully separate the lid sides with paper cutter, then use a very small minus screwdriver to pry the cover off. As you can see, I failed to preserve the beauty of it, but you might have better luck! | |
| [* black] (2) Now carefully pull the board on its sides with a pliers. Wiggle it a bit, the case had a small board holder pins on the other end. | |
| [* black] (3) Remove the power and volume buttons, by pushing the pins from the inside. I found it impossible to put back the board with these two parts on! | |
| [* black] (4) Drill couple of holes with a small hand drill or soldering iron. These holes will be the opening for the battery holder wires. |