crwdns2933803:03crwdne2933803:0
crwdns2933797:0watchmaniacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 watchmania
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Teardown |
|---|---|
| + | [* black] Now on to the main part. The first step would be to remove the board from the case, and prepare the modifications to attach the battery holder onto the case. |
| + | [* black] (1) This might be the trickiest part of the upgrade. The Ugreen case cover can be found on the bottom of the device, neatly glued. Carefully separate the cover sides with a paper cutter, then use a small minus screwdriver to pry off the cover. As you can see, I failed to preserve the beauty of it, but you might have better luck! |
| + | [* black] (2) Now carefully pull the board on its sides with a plier. Wiggle it a bit, as the case had a small board holder slot on the other end. |
| + | [* black] (3) Remove the power and volume buttons, by pushing the pins from the inside. I found it impossible to put back the board in later with these two parts on! |
| + | [* black] (4) Drill couple of holes with a small hand drill or soldering iron. These holes will be the opening for the battery holder wires. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0