crwdns2933803:02crwdne2933803:0
crwdns2933797:0Stevecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Steve
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] New solder points |
|---|---|
| [* black] Carefully remove your main board from the controller. Its not necessary to disconnect the two large ribbon that goes to the array of sensors. If you do be very careful. | |
| [* black] Locate the 6 soldering pads at the bottom of the controller near the USB port. Solder a wire to the first pad top left. | |
| [* black] Locate the 8 solder pads near the bottom left of the main board. Solder a wire to the top right pad. |