crwdns2933803:01crwdne2933803:0
crwdns2933797:0Clement Cheungcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clement Cheung
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* red] Remove the two Phillips 6mm screws at the base of the ring using a Phillips #0 screwdriver. |
|---|---|
| + | [* orange] Pull towards the base of the controller to release the black wire from the connector on the circuit board. |
| + | [* black] Pull the ring apart from the rest of the controller. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0