crwdns2894164:0crwdne2894164:0

crwdns2892164:01crwdne2892164:0

crwdns2892146:0Sam Goldheartcrwdnd2892146:0crwdne2892146:0

crwdns2875918:0crwdne2875918:0 crwdns2892120:0crwdne2892120:0 Sam Goldheart

crwdns2892174:0crwdne2892174:0
crwdns2892176:0crwdne2892176:0
crwdns2892148:0crwdne2892148:0

crwdns2892168:0crwdne2892168:0

-[* icon_note] The camera bracket is attached to the front panel by adhesive. The use of a heat gun to soften the adhesive is highly recommended.
-[* black] With the heat gun set on "low", begin heating the perimeter around the camera bracket.
-[* icon_reminder] It is suggested to heat the desired portion in a circular motion pattern to evenly dissipate the amount of heat throughout the device.
+[* icon_note] The camera bracket is attached to the front panel by adhesive. The use of an iOpener to soften the adhesive is highly recommended.
+[* black] Place the iOpener in the microwave and microwave it for ***one minute*** on the highest power setting.
+ [* icon_caution] Be careful not to overheat the iOpener during the repair procedure. We recommend waiting at least two minutes before reheating the iOpener.
+[* icon_reminder] Place the iOpener over the front facing camera on the front edge of the top of the display.

crwdns2892134:01crwdne2892134:0

crwdns2892140:0crwdne2892140:0

crwdns2892144:0crwdne2892144:0