crwdns2933803:03crwdne2933803:0
crwdns2933797:0Skeletwingcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Skeletwing
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Removing the Circuit Board |
|---|---|
| + | [* icon_caution] Buttons and button pads will fall out in the next steps. |
| + | [* black] Gently pull the circuit board up and out of the front case and set aside. |
| + | [* black] There's nothing holding either the pads to your board or the buttons into your front case, so take a moment to make sure you didn't drop any. |
| + | [* black] Remove any buttons you need from the front case. The Z button is the only one of note; there is a metal lever that sits in a groove and a post on the back side of it that sits in a hole to align the trigger. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0