crwdns2933803:04crwdne2933803:0
crwdns2933797:0Erik Maukcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Erik Mauk
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Use the opening pick to slice through any remaining adhesive. | |
| [* icon_note] If you have replacement adhesive strips, remove any remaining adhesive from the device frame using the Jimmy tool. | |
| [* black] Open the back cover slightly to the point that you can see the fingerprint sensor flex cable connector. | |
| [* icon_caution] The fingerprint sensor cable connects towards the top of the phone near the front-facing camera. Be careful not to pull the back cover off too violently to avoid ripping this cable. | |
| - | [* icon_reminder] To reconnect the fingerprint sensor cable during reassembly, angle the back cover until the flex cable lines up over its socket. Use the flat end of the spudger to snap the cable in place by gently pressing straight down. |
| - | [* black] Slowly flip the cover over and set it down on top of the rest of the device. |
| - | [* black] Disconnect the fingerprint flex cable using the spudger. |
| - | [* black] Remove the back cover. |