crwdns2933423:0crwdne2933423:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Ariel Sampsoncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ariel Sampson

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

+[* black] Use the opening picks to slice through any remaining adhesive.
+[* black] Open the back cover slightly and check that the fingerprint sensor cable has disconnected.
+[* icon_note] The fingerprint sensor cable connects to the back cover near the front-facing camera. The cable should disconnect as the back cover is removed. If the fingerprint sensor cable does not disconnect automatically, disconnect the cable with the point of a spudger before proceeding.
+[* icon_reminder] To reconnect the fingerprint sensor cable during reassembly, angle the back cover until the bale connector lines up over its socket. Use the flat end of the spudger to snap the cable in place by gently pressing straight down.
+[* black] Remove the back cover.

crwdns2933777:01crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0

crwdns2933777:02crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0

crwdns2933777:03crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0