crwdns2933803:03crwdne2933803:0
crwdns2933797:0Arthur Shicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Arthur Shi
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Set the pre-cut adhesive strip next to the back panel so that it is properly oriented. |
|---|---|
| + | [* black] Set the pre-cut adhesive strip next to the back panel so that it is properly oriented—the pull tabs should point to the bottom left corner of the back panel. |
| [* icon_note] Optionally, you can tape the pre-cut adhesive strip into position for easier application. | |
| - | [* black] Lay the pre-cut adhesive strip over the back panel, aligning it to the edges. |
| - | [* black] Tape one edge of the pre-cut adhesive strip to the back panel, locking the alignment in place while allowing the strip to still swing outward. |
| + | [* black] Lay the pre-cut adhesive strip over the back panel, aligning it to the long edges. |
| + | [* black] Tape one long edge of the pre-cut adhesive strip to the back panel, locking the alignment in place while allowing the strip to still swing outward. |