crwdns2933803:05crwdne2933803:0
crwdns2933797:0iRobotcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 iRobot
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Gently slide a plastic card or other thin pry tool under the adhered component. |
|---|---|
| + | [* black] Gently slide a [product|IF145-101|plastic card] or other thin pry tool under the adhered component. |
| [* icon_note] It may help to gently wiggle or twist the card as you go. If you're separating a battery, be careful not to deform or puncture it. | |
| [* black] If you're struggling, apply a few more drops of adhesive remover and wait about a minute before trying again. | |
| [* black] If your device has an especially tight fit and you have trouble inserting a tool, try working a piece of floss or wire underneath the component, and pull it side-to-side in a sawing motion to separate the adhesive. | |
| [* black] Lift and separate your newly-unglued component. |