crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Sahil Singhcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sahil Singh

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* icon_note] After the upper shell is removed, you can see a small green pad. This small green pad is the LED light.
-[* red] Unscrew the two screws and you should be able to take this small green pad off.
+[* icon_note] After the upper shell is removed, you can see a small green circuit board on either side of the middle part of the hoverboard. This is the LED light.
+[* red] Remove the circuit board by unscrewing the screws on either side and removing it.
[* black] Once you have taken it off, put on the new LED light and replace the screws.