crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Callie Shannahancrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Callie Shannahan

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] First flip to the back side to remove the screws using Phillips #1 screwdriver from the 54 bit driver toolkit.
-[* black] Last image shows what the hover board would look like when the back shell is removed.
+[* black] First flip to the board over to remove the screws using the Phillips #1 Screwdriver from the 54 bit driver toolkit.
+[* icon_note] The last photo in this step shows what the Hover-1 Matrix Board looks like without the back panel.