crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Jici Zhuangcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jici Zhuang

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Use screw driver to remove screws on the back of the hover board.
[* black] The second image shows what the hover board would look like when the back shell is removed.
-[* black] The third image shows which screw driver we used from the 54 bit driver kit.
+[* black] Use Phillips #1 screwdriver from the 54 bit driver toolkit.