crwdns2933803:04crwdne2933803:0
crwdns2933797:0kuljinder kaur dhamicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 kuljinder kaur dhami
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Using the Phillips #0 screwdriver, remove the J0mm screw which is shown in image one. This screw keeps the metal bar from sliding out. The laser lens are attached to this metal bar on one side and was attached to the bar with the sliding motor on the other side. |
|---|---|
| + | [* black] You can now slide out the rod from its placement. This will detach the laser lens and the ribbon cable from the tray. |
| + | [* black] You can now replace the Ribbon cable. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0