crwdns2933803:09crwdne2933803:0
crwdns2933797:0Aurimas Niekiscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Aurimas Niekis
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Mesh gears | |
| [* icon_caution] Baseplate should be parallel to the wheel otherwise wheels will mesh on angle and will cause negative effects. | |
| [* black] Attach wheel to the hanger and lower down motor to prepare gear meshing. | |
| [* icon_reminder] Motor gear and Wheel gear should be always parallel to each in all wheel position. If gears not parallel and at angle it can cause negative effects and product more noise than necessary. | |
| [* red] If wheel gear one side is pulled in or further than other sides check wheel hub bolts probably one bolt is more tighten than others or otherwise | |
| [* yellow] If wheel gear is more inside than motor gear use washers provided to pull wheel gear away from baseplate | |
| [* black] Loosen up motor bolts so that motor gear would press wheel gear. | |
| [* black] Use sheet of paper to drive it through wheel gear and motor gear. Spin wheel to push paper through the gears | |
| + | [* black] After meshing is good tighten motor bolts |