crwdns2933803:04crwdne2933803:0
crwdns2933797:0Steve Bondscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Steve Bonds
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Brush Bar Repair or Replacement |
|---|---|
| + | [* black] While this could have been trivially prevented with some routine maintenance had I know about it, the debris was causing enough heat to actually melt the brush bar. |
| + | [* black] The bearing itself is a metal ring with ball bearings at the end of the brush bar. |
| + | [* black] The sleeve area where the hair and plastic melted together is not supposed to be a bearing surface. This means that it doesn't need to be very smooth so an unskilled scraping with a utility knife to remove the melted plastic and debris is good enough to make it work. |
| + | [* black] Use a utility knife to carve/scrape away melted plastic and debris until it clears the end cap. It doesn't need to be pretty. |
| + | [* black] Optionally, replace the whole brush bar if it's too far gone or the repair goes poorly. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0