crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Gabriel Robinsoncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Gabriel Robinson

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Using the same PH1 Philips screwdriver and bit, remove the two 1.0 cm screws as shown and gently pull back green circuit board.
+[* red] Using the same PH1 Philips screwdriver and bit, unscrew the two 10.0 mm screws as shown and gently pull back the green circuit board.
[* icon_caution] Remove gently, circuit board is connected by wire to board. Removing cable from console case may allow more slack.
-[* icon_reminder] Spring may be under compression, don't lose it.
+[* icon_reminder] The button springs may be under compression, don't lose them.