crwdns2933803:03crwdne2933803:0
crwdns2933797:0Junreicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Junrei
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] There are 3 screws holding the outer metal cover on. |
|---|---|
| + | [* black] This reveals the circuit board. Be careful not to lose the rubber around the mic. |
| + | [* black] Make sure you don't lose the power switch. |
| + | [* black] Ribbon cable safety: Don't shear side to side. If disconnecting disconnect it using a pry tool at the connector, never by pulling up on the cable! |
| + | [* black] If removing the ribbon cable, once this cable is disconnected you can gently pull up on it (not bending too sharply!) to detach the adhesive from the speaker chamber |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0