crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Vincent Genovesicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Vincent Genovesi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Turn the plate over to reveal the white strip of connecting tape that connects the plate to the printer.
-[* black] Find where the tape is connected to the green button circuit board (Location circled in red)
-[* red] Place two fingers on the tape right where it connects to the plate and gently pull the tape out of the circuit board.
+[* black] Flip the plate over to reveal the white ribbon cable that connects it to the printer.
+[* black] Locate where the white ribbon cable is attached to the green button circuit board (circled in red).
+[* red] Hold the ribbon cable near the connection point and gently pull it straight out from the circuit board to avoid damage.