crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Hunter Borlikcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Hunter Borlik

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Remove the two connector brackets from the sensor board.
-[* icon_note] You need to squeeze the sides of the connectors then pull away from the circuit board.
+[* red] Remove the white cable from the sensor boards by disconnecting the cable on each side of the hoverboard.
+[* icon_note] To release the cable connector, squeeze the sides while pulling it away from the sensor board.