crwdns2933803:04crwdne2933803:0
crwdns2933797:0Alec Mcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alec M
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Lift and remove the rear panel | |
| - | [* icon_caution] When lifting the panel, make sure not to lift it too high, since you'll run the risk of tearing the cable, or damaging the connector on the board |
| + | [* icon_caution] When lifting the panel, make sure not to lift it too high, since you'll run the risk of tearing the cable, or damaging the connector on the board. |
| [* blue] Flip the lock on the flex cable connector up with a spudger. | |
| [* black] The front panel should pop off now that the cable has been disconnected. | |
| [* icon_note] When reassembling the device, make sure to insert the left side of the front panel first, since it has a small lip that needs to fit under the left part of the camera case. |