crwdns2933803:05crwdne2933803:0
crwdns2933797:0Robert Repaircrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Robert Repair
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] FAN implementation |
|---|---|
| + | [* black] With the FAN I used the original TV's heatsink again. Its housing fits flawlessly over the heatsink and inside the TV's rear housing. First trials I did with tape(photo) later I glued with hot glue to the mainboard. |
| + | [* black] without rear housing temperature dropped down to incredible 29degC (ambient temperature 21degC), however, with rear housing it rose up again to about 44 degC. |
| + | [* black] First I thought about drilling additional holes in the housing, but finally I decided just to remove the lateral and bottom output interface covers of the rear housing. This might be ok for you as well, as these covers are distal to the HOT area, so there is no risk of direct contact to high voltage. This way I now get 39 degC after several hours |
| + | [* black] Be aware, this method violates any standard to prevent you from inserting any metal object. So if you have a kid that could even think about, better keep the covers and accept the higher temperature. Additionally, without the covers you have to be more careful, not to damage the interfaces mechanically when inserting USB stick, antenna cable, etc. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0