crwdns2933803:07crwdne2933803:0
crwdns2933797:0stevecrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Place your battery in the rear panel, with the ***cable side down***, and use two small strips of tape to hold the cable against the solder pads. |
|---|---|
| + | [* black] Place your battery in the rear panel, with the ***cable side down***, and use two small strips of electrical tape to hold the cable against the solder pads. |
| [* icon_caution] Installing the battery upside down (with the cable facing up) will destroy the logic board. | |
| [* black] Place a strip of tape over the end of the battery ribbon cable to both cover two of the solder pads and hold the contacts down against the logic board. | |
| [* black] Heat the rightmost contact until the solder below melts and apply a small amount of solder to the contact, allowing it to flow through the two holes in the cable and down to the logic board. | |
| [* icon_caution] Do not apply too much solder. The amount required for a proper bond is miniscule. | |
| [* black] As soon as the solder has flowed into the joint, remove both the solder and the iron. |