crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Jeff Suovanencrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* icon_caution] Always keep your fingers completely clear of the knife, and be careful not to apply too much pressure, as this might cause the knife to slip and cut you, or damage the watch.
-[* black] Use a curved blade to get in between the thin gap between the display and the body (short side of the display closest to the digital crown.
-[* black] When the thin part of the blade went into the gap, tilt the blade towards you to widen the gap and lift the display slightly open.
- [* icon_caution] Do not insert the knife more than 1/16 of an inch (~2 mm).
+[* icon_caution] Always keep your fingers completely clear of the knife. Be careful not to apply too much pressure, as this might cause the knife to slip and cut you, or damage the watch.
+[* black] Place the edge of a curved blade into the thin gap between the display and the outer case. Start at the short side of the display, closest to the digital crown.
+[* black] Insert only the thin edge of the blade into the gap, and then tilt the blade towards you to widen the gap and lift the display slightly open.
+ [* icon_caution] Do not insert the knife more than 1/16th of an inch (~2 mm).