crwdns2933803:08crwdne2933803:0
crwdns2933797:0Ben Wardcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ben Ward
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Place new crank dynamo where the old one was previously housed on the back plate. Make sure to align screw holes on the dynamo to those on plate. |
|---|---|
| + | [* icon_note] Take note of the hexagonal key that transfers motion from the crank arm to the dynamo must be aligned with the corresponding hexagonal slot on dynamo. |
| + | [* black] Replace the four screws holding the dynamo in place. |
| + | [* black] Attach the wires from the new crank dynamo to the correct area of the main board, where the old wires were removed. |
| + | [* icon_note] Make sure grooves on the clip holding the red and black wires together align with the pins in the socket on the main board before inserting. |