crwdns2933803:01crwdne2933803:0
crwdns2933797:0Murathan Arazcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Murathan Araz
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* orange] Insert the [http://zaribo.org/hardware/12-linear-bushings-bearing-single-type-by-misumi.html|Misumi LM8UU] bearings to the x axis motor holder, |
|---|---|
| + | [* green] Use 3x [http://zaribo.org/screws-nuts/67-zaribo-screw-kit.html|M3x18 Socket Cap Screws] to mount the motor in place. |
| + | [* red] Push the [http://zaribo.org/other/63-2gt-6mm-belt-timing-pulley-16t-toothed.html|GT2 Pulley] to the motor shaft but to not fully tighten the small screws on the pulley yet. |
| + | [* light_blue] Insert [http://zaribo.org/screws-nuts/67-zaribo-screw-kit.html|M3 square nut] to its place. |
| + | [* yellow] Put the [http://zaribo.org/electronics/17-original-prusa-mk2-mk3-zaribo-edition-stepper-motor.html|X motor] cable flue on top and insert [http://zaribo.org/screws-nuts/67-zaribo-screw-kit.html|M3x12 Socket Cap Screw] to mount the flue for cable management. |
| + | [* blue] Push the [http://zaribo.org/stepper-motors/38-original-prusa-mk2-mk3-pom-nut-zaribo-edition.html|POM Nut] and align the holes with the ones on the X motor holder. |
| + | [* black] Use 2x [http://zaribo.org/screws-nuts/67-zaribo-screw-kit.html|M3x18 Socket Cap Screws and M3 Nuts] to fix the POM Nut. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0