crwdns2933803:011crwdne2933803:0
crwdns2933797:0Roberto Bartolaccicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Roberto Bartolacci
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Mount the heatsink and the fan | |
| [* green] Take the heatsink-fan block with two hands. Tilt it a bit and firstly insert the fan under the metal plate labeled as green. | |
| - | [* black] Once you have placed the fan as it is shown in the first picture, carefully lay the heatsink down by simply accompanying its tilting movement. If it is necessary, correct the trajectory in order to centre its screws with the holes. |
| - | [* orange] Fasten the 8 screws of the heatsink using a PH #00. Start from the one labeled as red and then follow the numerical order which is impressed on the heatsink. |
| - | [* icon_caution] Do not overwork these and all of the other screws when mounting. Do not apply heavy pressure with your hand: simply turn the screw until you run against the stop. |
| - | [* blue] Using a PH #00 remove the 2 screws (M2.5×4.5) |
| - | [* violet] Using a PH #00 remove the last screw (M2.5×6.5) that secure the fan to the top cover. |
| + | [* black] Once you have placed the fan as it is shown in the first picture, carefully lay the heatsink down by simply accompanying its tilting movement. If it is necessary, correct the trajectory in order to centre its screws and the holes. |
| + | [* orange] Fasten the 8 screws of the heatsink using a PH #00. ***Start from the one labeled as red ***and then follow the numerical order which is impressed on the heatsink. |
| + | [* icon_caution] Do not overwork these and all of the other screws when mounting. Do not apply heavy pressure with your hand. Simply turn the screw until you run against the stop. |
| + | [* blue] Using a PH #00 mount the 2 screws (M2.5×4.5) of the fan |
| + | [* violet] Using a PH #00 mount the last screw (M2.5×***6.5***) that secure the fan to the top cover. |
| + | [* yellow] Reinstall the fan cable. Hold it with your finger near the end and push it straight into the connector. |
| + | [* green] Reinstall the tape. Add eletrical tape to the edge in common beetween the heatsink and the fan if the thin stripe which was there was not sticky anymore as it was in my case. |