crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Danielcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Daniel

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Use wrench and slowly tighten the nut until it is about half a turn from touching the wheel.
-[* icon_note] Be careful not to cross-thread the axle nut. If turns become too difficult, you may need to unthread the nut to straighten it and then proceed with tightening.
+[* icon_note] Center the second bearing over the where your inserted the spacer and press down until the bearing rests in place.
+[* black] The bearing's outside edges should be flush with the the inside bottom edge of the wheel