crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Elizabeth Loilercrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Elizabeth Loiler

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] With the axle nut off you can now slide the wheel on and off. Depending on your set up there could be two small washers, one that goes on the axle before the wheel and one after the wheel.
-[* black] To remove the bearings and bearing spacer from the wheel, first slide the wheel so that it is half off the edge of the truck axle.
-[* black] Then pry the bearing that is still on the axle by prying the wheel about the end of the axle. The bearing should pop out and the bearing spacer that is loose inside will fall out after it.
-[* black] Flip the wheel around and pry out the other bearing in the same manner.
+[* black] Position the opening of the wheel at end of axle.
+[* black] Use axle to pry bearing out of the wheel.
+[* black] Repeat prying process for bearing on the other side of the wheel.
+[* icon_note] Bearing spacer should fall out after bearings are removed.