crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Victor Popovcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Victor Popov

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] By hand you can now adjust the positioning of the stem and handlebar so that is in line with the front wheel of the bike.
-[* black] Tighten the two bolts that clamp the stem to the steerer tube of the fork.
+[* black] Tighten the two bolts; 1 and 2 with a 7/32" Allen Wrench . These clamp the stem to the steerer tube of the fork.
[* black] Make sure that after tightening bolt 2 you go back and make sure you check the tightness of bolt 1 again. Since the bolts are used to clamp, bolt 1 will usually not be tight enough after tightening bolt 2.