crwdns2933803:06crwdne2933803:0
crwdns2933797:0Thomas Widmaiercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Thomas Widmaier
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove main PCB |
|---|---|
| + | [* green] Remove screws |
| + | [* red] Disconnect connectors for Lens assembly |
| + | [* blue] Carefully disconnect the tiny cable |
| + | [* violet] Next step is removing the PCB. I made the mistake not to take care about the battery compartment switch. If you are not careful, the black lever will break off. Not a problem though, because then the camera will work also with opened battery compartment |
| + | [* orange] Remove main PCB by slightly bending outward the cover for the jack with fingernail. Now lift the PCB slightly upwards. |
| + | [* black] Look under the PCB, there is a connector that needs to be separated by means of a small screwdriver or spudger. |
| + | [* black] Re-attaching the connector is not easy. I used a small screwdriver to carefully press the connector back in place. |
| + | [* black] Note: This is not the official method to do this. Normally the Top cover and several other parts need to be removed too. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0