crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:011crwdne2933803:0

crwdns2933797:0Sebastiancrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sebastian

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Setting up BIOS part 2
-[* black] Ifixit allows only 3 photos per step, so here are some more BIOS settings. Incidentally, I think the last one (Peripheral Setup) is the most important one.
-[* black] Don't forget to save the new settings when you're done. Then let the printer boot into its ASCII GUI.
-[* black] Edit in 2022: I set up a printer with a dead CMOS battery again. You have to set "Onboard FDC" to "Disabled".
+[* black] iFixit limits the number of photos per step to three, as such I had to split the BIOS settings into two steps. Notably, the Peripheral Setup setting is likely the most crucial.
+[* icon_reminder] Once you have adjusted the necessary settings, remember to save them before allowing the printer to boot into its ASCII GUI.
+[* icon_note] Update as of 2022: I recently configured a printer with a dead CMOS battery and found that you must set "Onboard FDC" to "Disabled".