crwdns2933803:019crwdne2933803:0
crwdns2933797:0Evancrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Evan
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Optional: Install CCD on Replacement Lens Assembly | |
| [* black] If your replacement lens assembly does not include a CCD (sensor), you can swap the CCD from the old lens assembly to the new one. | |
| [* black] Carefully scrape 5 glue dots from edges of CCD on old lens assembly. Note that photo is of a different camera & screw numbering is different; also, this would be done before lens assembly is installed. | |
| - | [* black] Remove 3 screws securing CCD to back of lens assembly and remove CCD, noting any tiny brass washers/spacers that may be present where screws were. |
| - | [* black] Remove rubber infrared filter gasket and infrared filter (small rectangle of bluish glass) from back of old lens assembly |
| + | [* black] Remove 3 screws securing CCD to back of lens assembly and remove CCD, noting any tiny brass washers/spacers that may be present where screws were. Remove CCD, being careful not to touch or get dust on sensor surface. |
| + | [* black] Remove rubber infrared filter gasket and infrared filter (small rectangle of bluish glass) from back of old lens assembly & install on back of new lens assembly. |
| [* black] Install CCD on back of new lens assembly (may or may not need to use brass washers to get alignment right for correct focus). | |
| [* black] Note: S100 & S110 CCDs are not interchangeable - ribbon connector for the S100 lens assembly is larger, & does not fit on the S110 board connector. |