crwdns2933803:03crwdne2933803:0
crwdns2933797:0Bryan Arringtoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bryan Arrington
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Out with the old. In with the new. |
|---|---|
| + | [* green] After removing the screw you can gently pry or pull the old knob off. Now would be a good time to clean out the crevices on the radio where the old knob sat. |
| + | [* green] You will now want to get your newly printed knob. Use the .stl file below to either print your own or have it printed and shipped to you. |
| + | [* green] I printed this one in ABS but it would probably be even better in PLA. I printed this one with the top on the print bed. (upside down) |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0